Dedicated Mircros Digital Sprite 2 Instrukcja Konfiguracji Pobierz pdf (Strona 19)

DS2 Network Guide

How to Congure Matrix Control

The unit can be incorporated into an existing analogue matrix installation and offers control of the

matrix via the Live web page or the Viewer software.

This ensures that any existing equipment does not need to be removed from the installation to allow

control over a network, simply integrate the unit into the system a network output.

The unit supports connectivity to the matrix on any of the Serial Ports. The following matrix protocols

are currently integrated into the unit’s software:

American Dynamics (AD) RS232 Matrix

AD168 RS232 Matrix

BBV TX1000, TX1500 and BBus-Interface Matrices

VCL/Ademco Maxcom Matrix

Connectivity

All video inputs from the matrix must be connected to the unit (loop through) as shown below, when

installed carry out the following conguration process:

1. Select System -> Serial Ports & Telemetry.

2. Using the drop down list on the associated Communication port (Serial 3 (Bus A) or

Serial 4 (Bus B)) select RS232/485 Telemetry.

3. Select the relevant matrix from the list of supported protocols.

The serial standard settings for the selected matrix will automatically be allocated,

however if this is incorrect you can change these for:

- Baud rate, Parity, Data bits, Stop bits, Flow control.

4. Enter the Matrix Monitor number of the matrix that the unit is connected to and that you

will be controlling.

5. Enter the Matrix Offset address.

6. Save the conguration by selecting the Save Settings!

7. Select Cameras -> Camera Inputs and select the matrix protocol from the telemetry list

for the corresponding camera.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 129 130

Brak uwag

Dedicated Mircros Digital Sprite 2 Instrukcja Konfiguracji Strona 19